![]() The shield will slot in perfectly with the Arduino Uno's pins. On ONE of the Sparkfun CAN-BUS shields, solder a single 1000 Ohm resistor (on the underneath) to its CAN-H and CAN-L pins.Īttach both Sparkfun CAN-BUS shields to an Arduino Uno. Solder pin headers onto both of your Sparkfun CAN-BUS shields. Setup and Usage Instructions Part 1 - Arduino CAN Bus Sniffer 1.1 - Hardware (Seeedstudio's) CAN Bus Shield Arduino Library:.(4x) Female-to-Female Solderless Breadboard Jumper Cables:.(Most vendors will provide one of these cables with your Arduino Uno purchase).(1x) Laptop (MUST running Linux or MacOS!).Thus, you could try a different CAN bus shield but you may need to tinker with the code. NOTE (2): The Arduino library used for this setup should work with any Arduino Uno compatible CAN bus shield that uses the MCP2515 CAN controller chip. Thus, you will need a soldering iron and solder to do this. NOTE (1): As the Sparkfun CAN-BUS Shield does not come with pre-soldered pin headers, you must solder these to the board yourself. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |